ELECTRICAL HEATED SILICONE ELEMENTS

The main characteristic of the heating silicone element is flexibility. These elements can take a multitude of shapes and cutouts to fit, surround and stick to the elements to maintain or increase the temperature.
The basic shape will be square or rectangle. We can add if necessary, eyelets, hooks and springs, scratch or self adhesive for fixing. 
The power can be adapted and a maximum temperature of use with 200° C, with possibility to rise up to 230° C maximum for 400.000h of continuous use.

• ​exists preformed to stick, be removed and reinstalled easily
• silicone foam as insulation on request
• high power possible
• almost total chemical resistance
• temperature range between -70 ° and + 230 ° C
• good mechanical properties and vibration resistant
• easy to place on drums and vessel

SELF ADHESIVE

Whatever the shape chosen, our silicone heating elements can be coated with a self-adhesive glue when the use of conventional fasteners is not possible. This makes it possible to keep an optimized contact between the heat and the vessel, but also to keep underneath any surface such as the bottom of a tank, under a parabola or against a vertical wall.
The self-adhesive heating element is easily repositionable. It is important to clean beforehand the surface on which it will stick.
Plan and design
Each form corresponds to a solution. With the help of your drawings, we will be able to offer you a design which will perfectly marry the roundings, the quills and the edges.

CUSTOMED HEATING SILICONE

​The solutions for building an electric heating silicone element are endless :
- voltage as low as 24V and as high as 400V
- glass silk reinforced / pure silicone 
- silicone foam insulation (6mm, 8mm, 12mm)
- normally in red, but other colors possible
- Pt 100 sensor / thermocouple K or J
- temperature limiter, thermostat, controller, freely plugged